Turn on 2FA for your organization
Admins decide whether members can use 2FA, and whether they must.1
Open the security settings
Open Settings and select Security. As an admin, you see your organization’s security options on this page.
2
Allow two-factor authentication
Turn on Allow Two-Factor Authentication. Members can now set up an authenticator app from their own settings. Nobody is forced to.
3
Require it (optional)
Turn on Require Two-Factor Authentication to make it mandatory. Members without 2FA see Two-Factor Authentication required and can’t use DeepMask until they set it up. Admins are exempt from this block.
4
Save
Save your changes.
Turning off Allow Two-Factor Authentication only hides the setup option for people who haven’t enrolled. Members who already set up 2FA keep it, so your organization’s security never weakens without anyone noticing.
Set up 2FA for your account
If your organization allows 2FA, you can set it up in a few minutes.1
Start setup
Open Settings → Security and select Enable 2FA.
2
Scan the QR code
Open your authenticator app and scan the QR code. If you can’t scan it, enter the code shown under Can’t scan? Enter this code manually. Then select I scanned the code, continue.
3
Save your recovery codes
DeepMask shows 10 recovery codes. Copy them with Copy all codes and store them somewhere safe, such as a password manager. They are shown only once. Confirm with I have saved these codes in a safe place.
4
Confirm with a code
Enter the current six-digit code from your authenticator app and select Turn on 2FA.
Finish setup within 5 minutes of starting it. If it takes longer, the setup expires. Close the dialog and start again.
Signing in with 2FA
When 2FA is on, DeepMask asks for a code each time you sign in from a new browser:- Sign in as usual.
- Enter the six-digit code from your authenticator app.
- Optionally select Remember this device for 30 days, then select Verify and sign in.
Recovery codes
Recovery codes let you sign in if you lose access to your authenticator app.- You get 10 codes when you set up 2FA.
- Each code works once. After you use it, it can’t be used again.
- To use one, select Lost your authenticator? Use a recovery code when DeepMask asks for your code.
Turn off 2FA
- Open Settings → Security.
- Select Disable 2FA.
- Confirm with a code from your authenticator app, or with a recovery code if you no longer have the app.
If you lose your phone
You have a recovery code
You have a recovery code
- Sign in using a recovery code.
- Open Settings → Security and turn off 2FA, confirming with another recovery code.
- Set up 2FA again with your new phone and save the new recovery codes.
You have no recovery code
You have no recovery code
Contact your organization’s admin or contact@deepmask.io. For your security, support verifies your identity before resetting 2FA on your account.
2FA and the Vault
Admins who manage the organization’s Vault need 2FA, and the Vault has stricter rules than sign-in:- Only authenticator codes count. Recovery codes, emailed codes, and remembered devices never open the Vault.
- Codes don’t carry over. Even if you just signed in with a code, you enter a fresh one to open the Vault.
- The Vault closes on its own. It stays open for at most one hour per session. See Open the Vault.
- New authenticators need a new sign-in. After setting up or replacing your authenticator, sign out and sign in again before opening the Vault.